Hi. I purchased several cans of Dicor self-leveling seam seal.
I'm re-caulking over the factory seal caulk. How did the factory get such a wide caulk line. Did they use a special nozzle.
I'm using a standard caulk gun, the bead is small compared to the factory.
Your thoughts.
Thanks!
Mark
On our 2009 LD, the Factory used a non-leveling polyurethane sealant. The sealant was troweled over the seams. I don’t know if the Factory used tubes of the sealant or some other method. When I use non-leveling sealant for a wide application, I cut the nozzle very large and make a large hole 🕳️ in the top of the tube. Then like the Factory, I trowel or spread it using masking tape to make an edge. Hope this helps.