Hello,
I'm digging into my water pump and hoping to winterize my LD.
Does anyone have any ideas why there is a tee on the pump's output line?
(http://www.lazydazeowners.com/MGalleryItem.php?id=3747)
Thanks for any help or advice!
-m
The shore water inlet connection will tee into the pump output line - but what is in your pic looks like an aftermarket kluge of some sort.
Steve
I agree with Steve, I have no idea what is going on other than is isn't Factory
I would remove this mess and. start over.
Larry
Hey Larry and Steve,
Thanks for the replies.
I do have an external shore water hookup. I haven't investigated where that plumbs into everything - as it is hard to access and I've just started digging in.
I agree that there is room for improvements. Are there any tutorials or instructions on "correcting" the pump placement and making things "right"?
Thanks for the advice!
-m
Looks like a prior owner wanted to pump water from the tank to somewhere external of the installed water system. A homemade outside shower, perhaps?
The shore water inlet connection will tee into the pump output line - but what is in your pic looks like an aftermarket kluge of some sort.
Steve
Right or wrong, maybe it was meant to be used to help winterize the fresh water system?
Looks like a prior owner wanted to pump water from the tank to somewhere external of the installed water system. A homemade outside shower, perhaps?
That was my guess too. I was camped with limited cell service and couldn't post until today.